QuinLED-Dig-Uno Board Dimensions

Back to index page

These measurements apply for the v2 and v3 versions of the board!

For the people wanting to integrate the QuinLED-Dig-Uno into a case or make a 3D printed design for it (check out this existing 3D printable case, it’s awesome), see the picture below the for the exact measurements of the board. You need to take about 30mm (about 1.18inch) of height into account.

If you are looking to use a closed box, this is possible but please limit the amount of Amps running through the board. If you want to use the specified values (up to 15A) a vented enclosure is highly recommended!

The screw holes in the board are M2.0 in size