QuinLED-Dig-Quad Board Dimensions
This article applies to v3 boards, please see here for v2 dimensions!
For the people wanting to integrate the QuinLED-Dig-Quad v3 into a case or make a 3D printed design for it, see the picture below the for the exact measurements of the board. You need to take about 3,5CM of height into account without Ethernet. If there is a QuinLED-ESP32-ABE (Ethernet) on there, the height is about 3cm higher to 6cm in total.
QuinLED-Dig-Quad v3 uses M2.5 screw holes.
If you are looking to use a closed box, this is possible but please limit the amount of Amps running through the board. If you want to use the specified values (up to 30A) a vented enclosure is highly recommended!
*Main design changes from v2 to v3 are larger power input terminals and slightly wider board dimensions (100,3mm)